MWS120
- Contact pressure can be adjusted manually from 0-24 N in 6 steps
- Compact axle spacing (120 mm) for flexible installation options
- Maintenance position can be reached manually
- Selection of various measuring wheel surfaces and diameters
- Incremental or absolute encoder interfaces can be combined
DBV50 Core
- Axis distance: 63.5 mm
- Measuring wheel circumference: 200 mm
- Resolution: 0.08 mm per pulse, 12.5 pulses per mm
- Max. spring travel: 14 mm, mechanically limited, max. spring force: 21 N
- Encoder rotation in 30° increments
- The encoder can be mounted on both spring arm sides, wheel support from top and bottom
- Adjustable spring pretension
DUV60
- Single or dual wheel measuring wheel encoder
- DIP switches for programming resolution, signal output,
- And counting direction
- Universal 4.5 V ... 30 V supply
- LEDs that indicate encoder status and output signal.
- M12 male connector, 4- or 8-pin, or universal cable outlet
- Optional fault output directly from encoder
DKV60
- Complete pre-assembled measurement system
- Measuring wheel with knurl or O-ring for adjusting to the measuring surface
- Mounting bracket made of stainless spring steel
- High resolution up to 0.1 mm (1 … 2,000 pulses/revolution)
- Electrical interfaces: Open Collector NPN, TTL/RS-422 or HTL/push pull.
- Connection via cable connection, can be used radially or axially with free cable ends or assembled with M12 male connector
DFV60
- Universal use, rotatable spring arm
- Wheel circumference 300 mm with O-ring made from NBR70
- Mounting arm and measuring wheels made from aluminum
- Programmable output voltage, zero pulse position, zero impulse width and pulse count.
- Connection: M12 radial plug-in connection or radial or axial cable connection
- Electrical interfaces: 5V & 24V TTL/RS-422, 24 VHTL/push pull
- Remote zero set possible